General Accessories

CLOSE

These are general accessories that can be used by several types of machines.

Angle Miter
  • TABLE SAWS
  • BAND SAWS
  • ROUTERS
  • SANDERS

The Angle Miter can be set to different positions and locked with the handle on top. It has a stop for 90 degrees and other commonly used angles. 

Push Stick
  • TABLE SAWS
  • BAND SAWS
  • ROUTERS
  • SANDERS

The Push Stick is used to feed stock and holds the stock flat on the table and tight against the fence. It also minimizes the risk to fingers.

Horizontal Feather Board
  • ROUTERS
  • TABLE SAWS
  • BAND SAWS
  • SANDERS

The Horizontal Feather Board will hold work tightly against the fence, hands free. It is held to the table by two strong magnets that are raised and lowered by the two thumb screws.

NOTE: The flexible ribs of a feather board must point in the direction of the feed right to left.

Vertical Feather Board
  • TABLE ROUTER
  • TABLE SAWS

The Vertical Feather Board holds the work tightly to the table. To use on the circular saw it needs a special jig and clamps which can be obtained from the maintenance room. It is more commonly used on the table router, the fence has a track that can hold the feather board with the thumb screws.

SLED
  • TABLE SAWS

The sled has two tracks that fit in the angle miter groves and are parrell to the saw blade. The fence holding the stock is perpendicular to the saw blade. Therefore, the operator can cut 90-degree angles very accurately. A piece of long wood can be held against the fence secularly and easier to handle then the angle miter tool. A stop can be attached to the fence so that multiple pieces can be repeatedly cut.

Metal Detector

A metal detector can be useful to check for nails, staples, wire etc. in wood. Especially reused wood or logs that may wreck blades or will set off the Stop Saw.